It sounds like you have replaced the Controller and Touchpad Assembly, # LC717666 for your Solera Smart Arm 12V Power RV Awning, # LC517517 due to moisture issues but are still having problems with function. Please note the attached snippet and follow these actions in attempt to reset.
- Press touchpad extend button.
- Press touchpad retract button.
- Press touchpad light button.
- Press touchpad wind button.
- Hold touchpad unlock button for 10 seconds.
You may also be looking at the... view full answer...
The Go Power Industrial Pure Sine Wave Inverter Charger # 34275013 has an automatic transfer switch built into it so since you are wanting a simpler setup this would be a great solution for you. This is a 3 in 1 unit that combines an inverter, a converter charger, and a transfer switch. view full answer...
Thank you for the picture with the measurement of your current Lippert Ground Control right rear leg that measures 24-1/2 inches from top to bottom when retracted. Based on that the correct replacement is the part # LC344792 and not the one you referenced as that one is shorter by 2 inches. There isn't a way to test the solenoids but if you checked all of the wiring connections already and there is still the error code you mentioned then it is time to replace the jack with the # LC344792 . view full answer...
Yes, the Adco SFS AquaShed RV Cover # 290-52255 will fit your 2017 Forest River Wildcat Maxx F295RSX. Your camper is 33'6" long and the cover you found fits 5th wheels 31' 1" to 34' long. The Adco Olefin HD RV Cover # AD49ZR is our best cover option if you are looking for the best cover you can get.
I recommend also getting 2 sets of the SnapRing TireSavers Tire Covers # ST7002WH to protect the tires from UV damage. I prefer these as they are simple to install and unlike the tandem tire... view full answer...
It is actually quite common for the front and center hangers to be different sizes on a tandem axle trailer. The idea behind this is that when you factor in the height of the equalizer and shackles, everything will be at a level height. In most cases the front and rear hangers will be the same, with a shorter center hanger. This is certainly not a universal rule, as different trailer manufacturers will do things differently. It sounds like what you are describing is more or less normal... view full answer...
You mentioned grease seals for your 5,200 lb Lippert axle, which we do have, but since you also mentioned mating with bearing # 25580, I'm not sure if you were possibly referring to the bearing races, so I'll just go ahead and give you both parts just in case. The correct grease seals for your 5,200 lb Lippert axle, and the races for bearing # 25580 are the following:
- Grease Seal # GS-2250DL
- Replacement Race for 25580 Bearing # 25520
I did verify with Lippert for you that these are... view full answer...